Shopping Cart: (0 Items)

Aqua-Tap Standard (Hot Tap Kit)

Aqua-Tap Standard Kit
Aqua-Tap Ready To Go

Aqua-Tap is the most complete, and efficient, hot tapping machine available.

Performs taps (through corp stops) for 3/4", 1", 1-1/2", and 2" service lines. Includes; 18 volt DeWalt cordless drill with two batteries and two chargers (standard & vehicle), cutters, corp stop adapters, coupon ejector, and carrying case. Iron Pipe Size (IPS) and Copper Type Size (CTS) corp. adapters are included.

Product Number: AT-K = COMPLETE TAP KIT w/18v Drill (3/4", 1", 1-1/2", & 2" TAPS)
Download Aqua-Tap Product Flyer - Instructions, Parts List and Tips
Directions:
  1. Take drill rod.
  2. Attach desired valve adapter
  3. Attach desired hole saw -Standard saw for PVC & AC - Tiger Cutters for steel
  4. Join unit to valve (hand tighten only)
  5. Attach Drill
  6. Drill hole (keep drill setting at low speed and in drill position).
Coupon / Plug Ejecting:
  1. Place drill in reverse.
  2. Grab onto saw with pliers
  3. Pull trigger
  4. Remove drill rod from drill and install Ejecting Rod.
  5. Install saw, & place drill in forward
  6. Grab onto saw with pliers
  7. Pull Trigger.

IMPORTANT TIPS
Follow ALL instructions. Failure to do so may result in property damage and/or personal injury.

  • Aqua-Tap is only to be used for tapping water lines. (DO NOT tap into gas, oil, air, steam lines, etc.)
  • Do not tap water lines with pressure exceeding 120 psi
  • Always wear eye protection
  • If tapping time exceeds 5 minutes, replace saw or pilot-bit
  • If wobbling occurs while drilling, do the following: Remove drill and replace again. (Check alignment with rod hex). If wobbling continues, replace drill rod.
  • Occasionally lubricate drill rod, and threads.
  • Tighten down cap against o-rings firmly to grip rod. If kickback occurs, replace o-rings (7/8" x 5/8").
  • Water leaking through valve adapter is normal. This does not mean tap is complete. Continue drilling until completely through the pipe wall.
  • When grabbing onto saw with pliers, grab onto nut, or base of saw only.
  • TO REPLACE WIRE ON A PILOT BIT: Using eye protection, have approx. 1/2" of wire sticking out of each side of the pilot bit and squeeze wire downward.
        Before tapping PVC pipe:
  • Do not tap within 3 feet of ends of pipe, or closer than 18" of other taps.
  • Avoid tapping a discolored pipe surface.
  • Only tap pipe that has been installed according to pipe manufacture's recommendations.
  • Install pipe saddle according to pipe manufacture's recommendations. (DO NOT over tighten)
  • Know locations of existing main valves, if necessary to shut off water system.
  • Have a quick exit. (Ladder, etc)
  • Have another employee near by.
  • Remove as much air as possible from the water system being tapped.